Error: Extruder sensor error or power is not enough
Printer: QIDI X-MAX
Solution:
The flat cable has a problem, when you wiggle it. The temperature at preheating->extruder jumps up to 1000 degrees.
Hello Linda
The problem comes up again even with the other extruder.
The problem is at the edge of the flat cable.
So when the head moves, the cable makes problem either with the connector or with the wires inside
regards
Raimund Popp
Ruemelinstr. 25
72622 Nuertingen
Email: Raimund.Popp@CodeDocu.de
Web: https://CodeDocu.de
Tel: +49 7022 9319004
Error Message on Qidi X-Max Printer
Replace the extruder with the high-temperature extruder